I replaced my temp sensor in my 81 CJ7. The old one was a 2 piece the large brass fitting into the block and then the temp sensor. It had a nut/bolt for the wire from the temp gauge to attach to. The replacement was a one piece sensor which was for a gauge with a spade connector. So now my gauge doesnt register. Which temp sensor do I need to install in the block so the factory gauge will read the tempature?
Thanks
rydog7

Lets try to upload pictures now!

The Transmission is a T176 Casting number C2604203 manual 4 steed. Is there anyone out there that would know where to find one? Engine is an AMC 304 V8

New owner of older jeep. Headlights are really dim when I turn them on and brighten with higher rpm's. Not the alternater. Any suggestions?

I thought I had valve issues since my No. 1 sparg plug is getting fauled with oil; performed a compression test, and cylinder No. 1 read zero, cylinder 2-5 read 140-150. If it possible that the head gasket is bad and I am getting by pass air on just one cylinder?
thanks

The JeepForum Project CJ7 is coming along really well! Ran into a few snags here there including finding out the front of the frame had been modified by the previous owner which we have to undo to correctly fit our Hanson front bumper and Smittybilt winch. Expect some great articles over the span of the next few weeks on products we have installed and modifications that have been done.

Today our meats came in! 35x12.5 Interco TrXus Mud Terrains. We have to finish our BDS lift install and then these bad boys can hit the axles. Can't wait to test them out. We've ran the TSL/Radials and TSL/SX in the past. Both tires gave outstanding performances both on the rocks and mud. We wanted to curb it down a little for this project because it's going to see more road action than the previous two.

Stay tuned!